4 Basic Steps For Replacing a Leaky Toilet

3/23/2020 (Permalink)

Replacing a leaky toilet in Port Malabar, FL

Replacing a Leaky Toilet

Your toilet was built to last a long time, but it cannot last forever. Over time, the fixture may begin to work less efficiently and can break or develop cracks. If you have decided that it is time to replace the leaking toilet in your Port Malabar, FL home, here are some basic steps to help you get the job done.

1. Disconnect the Supply Line

Before you begin any work on the toilet, you need to make sure that it is no longer connected to the water supply line. Drain as much water from the toilet as you can and dry the rest with a sponge or towel. This will prevent any messes during the removal.

2. Remove the Old Toilet

Once the leaking toilet has been dried, you can begin the process of removing it. You should unscrew any bolts that are securing it to the floor and then move the fixture back and forth gently to break the wax seal before moving the commode to another area.

3. Prepare the Area

After the old toilet has been removed, you will need to clean up the area before you can install the new one. You should scrape off any wax that remains on the gasket and check that nothing has been damaged during the process. If everything looks fine, then you can proceed to the next step.

4. Install the Toilet

If the leaking toilet has been removed successfully and there are no damages to the area that need to be repaired, you can begin the installation. Make sure that the toilet is placed correctly and is parallel to the wall behind it before securely tightening the bolts. Depending on your building code, you may need to seal the base with caulk.

If you don’t feel confident replacing your toilet on your own, or if there is already damage in your bathroom, a water damage repair service might be able to help. They can make any necessary repairs and ensure that everything is installed correctly to prevent the need for future toilet overhauls.